ChemNet
 
Previous article Next article Contents  

K. N. Smirnov, I. A. Dyatchkov, A. V. Pirogov, O. A. Shpigun

Influence of the synthesis pressure on the chromatographic properties of poly(divinylbenzene-co-ethylvinylbenzene-co-2-hydroxyethyl methacrylate) monolithic columns

Abstract

Monolithic columns based on copolymer of divinylbenzene (DVB), ethylvinylbenzene (EVB) and 2-hydroxyethyl methacrylate (HEMA) were prepared and applied to the separation of low-molecular-weight aromatic compounds. The monoliths were synthesized via thermally initiated free-radical polymerization in confines of stainless steel tubes with dimensions of 100´4,3 mm. In order to compensate for the polymer shrinkage during the synthesis and prevent the monolith from detachment from the column wall, the polymerization was conducted under nitrogen pressure. The excess pressure was varied from 0 bar to 9 bar. The synthesis under pressure was shown to improve the peak shapes and column efficiency in comparison with the synthesis in the closed tube. The optimum pressure for poly(DVB-co-EVB-co-HEMA) monoliths was found to be 3 bar. The efficiency of the column obtained at 3 bar is 13500 plates/m for propylbenzene (k¢ = 6) and 38300 plates/m for uracil (k¢ = 0).
Moscow University Chemistry Bulletin.
2011, Vol. 52, No. 6, P. 426
   

Copyright (C) Chemistry Dept., Moscow State University, 2002
   Overview
   Editorial board
   Tables of Contents
   Subscription

The site is supported by Russian Foundation for Basic Research
  The using of published on this page materials is not allowed without special permission
Copyright (C) Chemisty Department of Moscow State University
Web-Editor: B.I.Pokrovskii
Web-design: Copyright (C) MIG and VVM
webmaster@www.chem.msu.su